Olicom 2 User Manual download pdf (Page 15)

SY-P4I865PE Lite DRAGON 2

Quick Start Guide

Hardware

Installation

This motherboard only support 1.5V AGP card (4X/8X card). If 3.3V AGP card is

used, the system will not boot-up and the AGPDET LED will lit.

CMOS Clear (JP5)

In some cases the CMOS memory may contain wrong data, follow the steps below to

clear the CMOS memory.

1. Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5. This

jumper can be easily identified by its white colored cap.

2. Then put the jumper back to 1-2 to allow writing of new data into the CMOS memory.

CMOS Clearing Clear CMOS Data Retain CMOS Data

JP5 Setting

Short pin 2-3 for

at least 5 seconds to

clear the CMOS

Short pin 1-2 to

retain new

settings

Note: You must unplug the power cable from the ATX power supply when

performing the CMOS Clear operation.

12 3

AGP Slot

If use 3.3V AGP card,the system will not power on and the AGPDET LED will lit.

(1.5V only)

(When AGPDET LED lit, it m eans 3.3V AGP card is used.)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 33 34

No comments

Olicom 2 User Manual Page 15